Στα νερά λέει ο κατασκευαστής του υγρού..
Κάπου μπερδευτηκες..
Ολα καλα...
Normal treatment
Replace old liquid by water. Add Wynn’s Cooling System Flush to the water. Let the
engine run for 15 min. Drain this mixture and rinse with water. Refill system with
water. Remove the upper radiator hose and the thermostat. Shake the bottle of
Wynn’s Cylinder Block Seal before use. In cold temperatures, warm the bottle. Pour
Wynn’s Cylinder Block Seal into the opening of the removed thermostat (325 ml treats
circuits up to 8 litres). Replace the dismantled parts to close cooling system again
(thermostat is NOT replaced). Top up liquid level with water. Warm up engine. After
warm-up let the engine run for at least 15 to 20 minutes. Check water temperature
during treatment. Stop the engine. Drain when engine is cold and flush completely.
Fill with cooling liquid (antifreeze + water). Replace thermostat
Cracks in cylinder wall
Proceed in the same way, but remove the spark plug (petrol) or injector (diesel) from
the damaged cylinder. When several cylinders are damaged, remove the spark plugs
(injectors) sequentially, leaving each one out for 5 minutes.
For large cracks
Proceed in the same way, but leave Wynn’s Cylinder Block Seal in the cooling system
for 3 to 4 days, before draining.
If the product is spilled on glass or paint, remove immediately with clean water.
Use Wynn’s Cooling System Stop Leak to prevent and stop leaks in the radiator.
__________________
Τα "μαστόρια" χαλάνε τα αυτοκίνητα μας....
|