|
#42
18-01-08, 09:44
|
|||
|
|||
|
Και εγώ από τον Intercare πήρα τον δικό μου προφυλακτήρα όπως και τα fog lights, τα ίδια καλά λόγια έχω να πώ.
Έχω ένα πρόβλημα όμως, ο δικός μου είναι λίγο έξω σε σχέση με τα φτερά 5mm σε κάθε πλευρά, μήπως υπάρχει τρόπος να το φτιάξω?   Painted in Topaz Blue  Old Bumper 
|
|
#43
18-01-08, 09:44
|
|||
|
|||
|
Lifted the car a bit by driving it on two wooden blocks
 Remove fog lights by unscrewing the 1 screw that holds them in place. The black trim just pulls out and is held by some clips.  Remove the license plate holder. 3 screws  Remove the two huge Torx screws. Make sure they are completely removed before pulling the bumper. 
|
|
#44
18-01-08, 09:45
|
|||
|
|||
|
Use the factory jack to lift each side a bit so that you can access the two screws on each side that hold the splashers in place with the bumper
   After all screws are removed, slide the bumper out and disconnect the two plugs from the horns 
|
|
#45
18-01-08, 09:46
|
|||
|
|||
|
Bumper from the inside
 The aluminum bar must be transplanted to the new bumper. Held in place by some plastic clips!  Once the metal bar was secured in place, the new bumper just slides in place. Me doing some fine tuning  The plastic grill was a bitch to install as well 
|
|
#46
18-01-08, 09:47
|
|||
|
|||
  License plate holder in place  Final alignment before tightening bolts/screws 
|
|
#47
18-01-08, 09:47
|
|||
|
|||
|
Washing the car!
  Done!  
|
|
#48
18-01-08, 09:48
|
|||
|
|||
   
|
|
#49
18-01-08, 09:49
|
|||
|
|||
|
|
#50
18-01-08, 10:12
|
||||
|
||||
|
Tα κενα που κανει κατω απτα φαναρια πως τα μαζευουμε????
__________________
If you smell...what Geo is cookin!!!!!  Παράθεση:
|
 |
|
|
Αλλαγή σε γραμμικό τρόπο
